In this project, I used the ESP32 WROOM-32 development board in combination with the Neo-6M GPS module to acquire real-time satellite-based location data. The hardware components were interconnected using hardware serial (UART) to ensure reliable communication between the ESP32 and the GPS module. The wiring setup is illustrated below. Neo-6M GPS Module | ESP32 WROOM-32 Vcc =====> VIN (3.3V) GND =====> GND TX =====> GPIO16 RX =====> GPIO17 Snapshot of the NEO-6M GPS Module used in this project: Front View of the NEO-6M GPS Module Backside of the NEO-6M GPS Module Snapshot of the ESP32 WROOM-32 Arduino board used in this project: After the interconnecting these two boards you have to follow following procedures. Install TinyGPS++ library: Open Ardui...